theallelectricsmartgrid

September 13: post-merge MAYA run with failures, then a long clean run

All times are September 13, 2026, Pacific Daylight Time. These are two observational SmartGridOne runs on the iPad through the USB hub with MAYA44 USB+ and WRLD.BLDR. They were not controlled A/B trials, and the retained evidence does not by itself establish why the failure rate changed.

3:54–4:39 PM app session; 4:19–4:34 PM failure cluster

Evidence: app timing extract, MAYA system episode, full app log, and system archive. The recording header is /private/tmp/sgo-20260913-1515-1645/recording-2026-09-13T161755.270.header.bin. Raw artifacts under /private/tmp are outside Git and may later be garbage-collected.

7:30–9:14 PM app session; no settled-run USB failure

Evidence: app log, USB-subsystem extract, end-transition extract, and system archive. The archive viewer warned of a wall-clock adjustment when queried with --end; timestamps above were cross-checked against app logs and the separate end-transition query. This was a log-based check, not an analog-output recording, so it cannot exclude audible artifacts without USB errors or app counter changes.

Comparison

The afternoon episode reproduces the established failure chain: MAYA input transfer error → driver I/O restart/lock delay → roughly 320 ms app callback gap. The evening run shows that the same iPad/MAYA topology can remain free of that logged chain for about 1 hour 43 minutes after startup, even though initial enumeration was noisy. The difference is real within the captured logs, but neither run isolates its cause. In particular, startup aborts and the user-quit restart in the evening should not be grouped with spontaneous mid-session 0xe00002ed failures.